老牛嫩草国产一区二区三区

威格士插装式比例节流阀，CV1 6885

老牛嫩草国产一区二区三区

公司蚕蚕；2880626089

电话；021-39526589

手机；13564956558

邮箱；13564956558蔼163.肠辞尘

联系人；居琦

此联接机构，在用

与加工结合安装

凸缘，提供了对准

泵电机。振动是

小化作为结果。

如果有必要移除或

取代以任何理由泵，

对准，而不需要实现

指示轴，并分别对齐

泵电机。

This coupling mechanism, used in

conjunction with the machined mounting

flange, provides for precise alignment of

the pump to the motor. Vibration is

minimized as a result.

If it becomes necessary to remove or

replace a pump for any reason, precise

alignment is achieved without the need

to indicate shafts and separately align

the pump to the motor.

The entire area around the splined

coupling is bathed in oil and sealed by a

static o-ring seal formed by the

mounting flange and the pump itself. In

addition, any minute shaft seal leakage

from the pump stays within the sealed

motor.

周围的花键的整个区域

耦合在油浴并通过一个密封

由静电形成翱型密封圈

安装凸缘与泵本身。在

此外，任何分钟轴封泄漏

从内部密封泵住宿

发动机。

进口条件

标准模型需要一个积极的入口

压力，通常通过使用一个提供

塔顶贮存器（图1）或一个“尝”

形储存器（图2），其油

平达电机泵空气排放口

连接。较大正入口

压力为2巴（29磅）。

维克斯建议积极入口

压力对于所有电机泵

安装。

注：在启动，电

马达应该充满液压流体Inlet Condition

Standard models require a positive inlet

pressure, normally provided by using an

overhead reservoir (Figure 1) or an “L”

shaped reservoir (Figure 2) with its oil

level up to the motor pump air bleed port

connection. The maximum positive inlet

pressure is 2 bar (29 psi).

Vickers recommends a positive inlet

pressure for all Integrated Motor Pump

installations.

NOTE: Prior to start-up, the electric

motor should be filled with hydraulic fluid

威格士插装式比例节流阀，CV1 6885